JLG G6-42A Operator Manual - Manual (Page 105)

Section 5 - Attachments
5-29 31200744
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
page 5-9.
• Ensure length and cross section of the parent fork arm is equal to or exceeds the
parent fork arm blade length stamped into the fork extension.
• Secure the fork extensions to the forks by sliding the fork extensions onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
Operation:
• Heavy part of load must be against carriage backrest.
• Do not allow load center of gravity to be in front of tip of the supporting fork.
• Do not pick up a load or pry materials with tip of fork extensions.