7 battery charging, Operation, Battery charging -8 – JLG 3246ES Operator Manual User Manual
Page 58: Operation -8
SECTION 4 - MACHINE OPERATION
4-8
– JLG Lift –
3121165
4.7
BATTERY CHARGING
Operation
NOTE:
Be sure that machine is parked in a well ventilated area
before charging begins.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND GROUNDED
OUTLET. DO NOT USE GROUND ADAPTORS OR MODIFY PLUG. DO NOT TOUCH
NON-INSULATED PORTION OF OUTPUT CONNECTOR OR NON-INSULATED BAT-
TERY TERMINAL.
ALWAYS DISCONNECT THE AC SUPPLY BEFORE MAKING OR BREAKING THE
CONNECTIONS TO THE BATTERY BEFORE CHARGING.
DO NOT OPEN OR DISASSEMBLE CHARGER.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR IF THE
CHARGER HAS RECEIVED A SHARP BLOW, BEEN DROPPED, OR OTHERWISE
DAMAGED IN ANY WAY.
The battery charger receptacle is located at the right rear of the
machine near the ground control panel.
1. Connect the charger to a grounded outlet.
2. On the Battery Charger, the charger will automatically
turn on and go through a short LED indicator self-test.
All LED’s will flash in an up and down sequence for two
seconds.
3. The batteries are fully charged when green light on
the battery charger status panel is illuminated.