Belkin Home Base F5L049 - Manual (Page 9)

7
Home Base
sections
table of contents 1 2 4 5 6 7 8 9 15 10 11 12 13 14 3
WIreless seTUP
1 . Read the PIN code from the bottom of Home Base.
2 . Make sure Home Base is NOT plugged into your router.
3 . Connect the AC adapter.
4 . Push and hold the WPS button on Home Base. Release the WPS
button when the security LED on Home Base starts blinking short
blinks after about 10 seconds.
5 . Enter the PIN code into your router’s interface. (Refer to your
router’s instruction manual.)
6 . Home Base and your router will negotiate a connection.
If a connection is established, Home Base’s security LED will come on
in solid blue.
If a connection is not established after more than two minutes, the
security LED will flash quickly and continuously for 10 seconds, then
stop, and you’ll need to try again.
For more information on wireless setup, see the “Troubleshooting” and
“FAQs” sections in this manual.
WPs PIn Configuration
If your router does not support the WPS Push Button Configuration, the alternative is to apply the WPS security using the PIN
Configuration. Locate the 8-digit PIN code on the bottom of Home Base and enter this pin into your router to manually initiate a
WPS connection.