Eppendorf Rolling Cabinet - Manual (Page 15)

Installation
Rolling Cabinet
English (EN)
15
4.3.1 Mounting the foot holders
Proceed as follows to mount the foot holders and seal the non-required boreholes:
1. Secure the castors with wheel stops.
2. Check which boreholes match the centrifuge.
3. Insert plastic plugs in the non-required boreholes
The plastic plugs must be flush with the surface of the rolling cabinet.
5. Use the Allen key supplied to bolt down the foot holders in a clockwise direction.
CAUTION! Risk of injury due to non-mounted foot holders or incorrect
positioning of foot holders.
The centrifuge may slip off the rolling cabinet if the centrifuge device feet are
not in the foot holders.

Use the foot holders that match the centrifuge type.

Ensure that the boreholes match the centrifuge type.

Center the centrifuge device feet in the foot holders.
NOTICE! Damage due to penetrating liquid.
Penetrating liquid can cause corrosion damage on the rolling cabinet and the
contents of the drawer.

Seal the non-required boreholes on the upper side of the rolling cabinet.
The centrifuge type can be found to the left front side of the centrifuge or in the
display after the centrifuge has been switched on.
Seal the non-required boreholes before bolting down the foot holders.
4. Position the foot holders on the
boreholes.