Snorkel TB85J Fixed Axle CE - Manual (Page 39)

Chapter 7 – Prestart Inspection
TB80/TB85J Fixed Axle – 0112823EE 35
Electrical Power Outlet
With the engine running, place the machine/generator
control (refer to Figure 7.23) in the generator position to
provide electrical power to the two electrical outlets at
the platform and to the outlet on the end of the generator
housing.
Figure 7.23 – Upper Control Panel Front
Plug an electrical tool into the receptacle at the platform
and at the generator and try to operate the tool to verify
proper operation of the outlet.
Drive Motion Alarm
The machine may be equipped with an optional drive
motion alarm. Drive in both the forward and reverse direc-
tions to ensure that the alarm sounds to warn personnel
in the area that the aerial platform is in motion.
Driving and Work Lights
The machine may be equipped with driving lights and/or
platform work lights. Turn the engine on and use the switch
on the back of each light to momentarily turn it on to see
that it works.
Platform Control Cover
The machine may be equipped with an optional platform
control cover. Inspect the cover to ensure it fits properly
over the control panel.
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition, and
are legible.
The placards and decals may be cleaned with soap and
water, and a soft cloth if the words or pictures cannot be
seen.
A
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and dis-
posal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural bio-
degradable solvent and a soft cloth.
Replace any missing or illegible placards or decals be-
fore operating the aerial platform. Placard and decal kits
are available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.
Machine/Generator Switch