Snorkel SR SERIES - Manual (Page 57)

10. DAILY INSPECTION & MAINTENANCE
10 - 9 P/N 569300
Listen for the lowering alarm while the platform is
going down. Listen for the motion alarm while the
SR is being driven forward. Listen for the back-
up alarm while the SR is backing up.
Press the operator horn (5) to see that it works.
Pay particular attention to the EMERGENCY
STOP switch (6) to see that it turns the engine
off when struck.
Pay particular attention to the SAFETY
CONTROL (7) to see that it deactivates the
JOYSTICK CONTROLLER (8) when the
SAFETY CONTROL (7) is released.
26. Flashing light (option)
Check to see that the light flashes approximately
once a second when the SR engine is running.
27. GFCI (option)
If the SR does not have the generator option,
connect a source of power to the GFCI (ground
fault circuit interrupt) plug at the base-control
panel. Set the AC OUTLET SWITCH to on (-).
Push the TEST button (1) in on the GFCI). The
RESET button (2) should pop out. Press the
RESET button (2) back in.
28. Air filter
Visually check the viewing area (1) on the air
cleaner service indicator (2) to see that it is clear.
If it is red, change the air filter and push the reset
button on top of the air cleaner service indicator.
29. Safety prop
Inspect the safety prop(s) to see that it is present
and moves freely.
30. Parking brakes
Visually check to see that the pin (2) is engaging
and that there is enough surface (1) to hold the
pin when it engages. Also check the brake
release cam (3) to see that it moves freely.