Snorkel SR SERIES - Manual (Page 32)

7. OPERATION
7 - 2 P/N 569300
4
4. For LP operation: Completely open the valve
(4) on top of the LP tank (unscrew
counterclockwise until it stops).
5. For a dual-fuel engine: Set the FUEL switch
(9) to LP fuel (5) or gasoline fuel (6), depending
on which you want to use.
6. If the engine is cold, press and hold the
CHOKE switch (7) during the next step.
7. Turn the key (8) to start and hold it there until
the engine starts or for 20 seconds, whichever
comes first. When the engine starts, release both
the key (8) and the CHOKE switch (7).
C A U TIO N
If the engine does not start in 20 seconds, turn
the key (8) to off and release the CHOKE switch
(7) then wait 60 seconds before trying to start the
engine again.
Y Starting a Diesel Engine
To start a diesel engine from the base-control
panel do the following:
1
1. Set the BATTERY switch (1) to ON.
2. Set the EMERGENCY STOP switch (2) to on
(up).
3. Set the BASE/PLATFORM SELECTOR switch
(3) to base.
4. Turn the key (4) to on -- do not turn the key (4)
to start.
5. If the engine is at ambient temperature,
momentarily press the GLOW-PLUG switch (5).
This action will automatically turn the glow-plugs,
in the engine, on for 10 seconds. A light (6) will
automatically come on to indicate that the glow-
plugs are on.