Snorkel SR SERIES User Manual

Page 16

2. SAFETY DEVICES

2 - 4

P/N 569300

GFCI AC OUTLET (option)

The GFCI (ground fault circuit interrupt) is
located under the platform-control box. To use
the outlet set the AC OUTLET SWITCH to on (-).

NOTE: If the SR does not have the ac
generator option, connect a source of power
to the GFCI plug at the base-control panel.

The GFCI will protect against short circuits to
ground. When there is a short to ground the
GFCI will shut off power to the outlet.

To reset the outlet:

Unplug the equipment being used.
Press the RESET button on the GFCI outlet.

This should restore power to the outlet. If it does
not, set the AC OUTLET SWITCH to off (O) and
refer the problem to a trained service technician.

FLASHING LIGHT (option)

The flashing light alerts people that the SR is
present and that the SR is moving. The light
flashes at about one flash per second any time
the SR engine is running. There is no ON/OFF
switch for the flashing light, it cannot be turned
off while the SR is running.

LANYARD ANCHOR POINTS (option)

There are four anchors on the floor of the
platform, one at the front of the roll-out deck, one
at the back of the platform, and one on each side
of the platform.

NOTE: These anchors are not for lifting or
tying down the machine.

You should attach your fall protection to the
anchors if work rules require it.