Snorkel S3246 CE - Manual (Page 32)

Chapter 8 – Prestart Inspection
28 S2646/3246 – 0410063EE
Lowering Alarm and Interrupt
Raise the platform approximately 3 m (10
′
). Push the
joystick forward to lower the platform. The platform should
stop lowering when it reaches about 1.5 m (5
′ ). Center
the joystick in neutral to reset the lowering function. Wait
for 5 seconds and then push the joystick forward to con-
tinue lowering.
Drive Motion Alarm
Drive in both the forward and reverse directions to ensure
that the alarm sounds to warn personnel in the area that
the aerial platform is in motion.
Flashing Light
If the machine is equipped with the optional flashing light,
visually check to see that it flashes. The light should
flash when power is turned on to operate the machine.
Battery Condition Indicator
The optional battery condition indicator (refer to Figure
8.21) is located on the upper control panel.
Figure 8.21 – Electrical Power Outlet
With the machine set up to operate from the upper con-
trols, check to see that the battery condition indicator
gauge displays a power reading.
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition, and
are legible. The placards and decals may be cleaned
with soap and water, and a soft cloth if the words or pic-
tures cannot be seen.
A
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and dis-
posal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural bio-
degradable solvent and a soft cloth. Replace any miss-
ing or illegible placards or decals before operating the
aerial platform. Placard and decal kits are available from
Snorkel.
The safety related placards and decals are illustrated on
the following pages. Battery Condition Indicator Battery Condition Indicator