Snorkel X Series-sn13600-15019 - Manual (Page 7)

7
Routine Service
Use the following table as a guide for routine
maintenance, refer to the Service Manual for
complete service instructions.
SERVICE OPERATION INTERVAL
Monthly 6 Months 2 Years
Daily or or or
50 Hrs. 250 Hrs. 1000 Hrs.
Clean entire work platform X
Check battery fluid level X
Charge batteries X
Check tires for damage X
Check lug nuts/bolts X
Check hydraulic fluid level X
Check for peeling, faded or
X
missing labels & replace
Check deck and guardrail
X
fasteners for proper torque
Inspect elevating assembly
X
for bends or cracking
Check for & repair collision
X
damage
Check emergency lowering
X
valve operation
Check electric motor
X
brushes
Check pivot pin bolts for
X
proper torque
Change hydraulic filter
X
Check all fasteners for
X
proper torque
Change hydraulic fluid
X
Grease front spindle bearings X
Grease pot hole protection cylinder
rod end bearing
X
Figure 7: Blocking Elevating Assembly (X20N,
X20W, X26N)
Blocking Elevating Assembly (X31N)
See Figure 8
Installation
1. Park the work platform on firm level ground.
2. Verify both Emergency Stop Switches are ON.
3. Turn Chassis Key Switch to CHASSIS.
4. Position Chassis Lift Switch to UP and elevate
platform approximately nine (9) feet (2.7 m),
leaving enough room to freely rotate the
Scissors Brace.
5. Pull out on the retaining pin and rotate the
Scissors Brace into vertical position.
6. Push Chassis Lift Switch to DOWN position
and gradually lower platform until the upper
and lower pivot pins rest on the Scissors
Brace.
Removal
1. Push Chassis Lift Switch to UP position and
gradually raise platform until the Scissors
Brace will clear the pivot pins.
2. Rotate the Scissors Brace counterclockwise
until it locks into position parallel with the
scissor arm.
3. Push Chassis Lift Switch to DOWN position
and completely lower platform.
Figure 8: Blocking Elevating Assembly (X31N)
Retaining Pin
Scissors Brace
Scissors Brace