Snorkel X Series-sn13600-15019 - Manual (Page 6)

6
Maintenance
Never perform service on the work platform
in the Elevating Assembly area while
platform is elevated without first blocking
the Elevating Assembly.
DO NOT stand in Elevating Assembly area
while installing or removing brace.
Blocking Elevating Assembly (X20N,
X20W, and X26N) See Figure 7
Installation
1. Park the work platform on firm level ground.
2. Verify both Emergency Stop Switches are ON.
3. Turn Chassis Key Switch to CHASSIS.
4. Position Chassis Lift Switch to UP and elevate
platform approximately nine (9) feet (2.7 m).
5. Rotate Scissors Brace towards the front and
allow it to hang vertical over the lower scissor
pivot tube.
6. Push Chassis Lift Switch to DOWN position
and gradually lower platform until brace rests
on lower scissor arm pivot tube.
Removal
1. Push Chassis Lift Switch to UP position and
gradually raise platform until the lower end of
the Scissors Brace will clear the lower scissor
arm pivot tube.
2. Rotate Scissors Brace towards the rear so that
it rests on the cylinder mount, stowed position.
3. Push Chassis Lift Switch to DOWN position
and completely lower platform.
Transporting Work Platform
By Forklift
NOTE: Forklifting is for transporting only.
See specifications for weight of work
platform and be certain that forklift is of
adequate capacity to lift platform.
Forklift from the rear of the machine using the
forklift pockets provided. If necessary, the ma-
chine may be forklifted from the side by lifting
under the Chassis Modules.
By Crane
1. Secure straps to Chassis Lifting Lugs only
(Figure 5 & 6).
By Truck
1. Maneuver the work platform into transport
position and chock wheels.
2. Secure the work platform to the transport
vehicle with chains or straps of adequate load
capacity attached to the chassis tie down lugs
(Figure 5 & 6).
Front tie down lugs are not to be used to lift
work platform.
Overtightening of chains or straps through
tie down lugs may result in damage to work
platform.
Figure 6: Front Tie Downs, Lifting Lugs
Figure 5: Parking Brake Release, Rear Tie Downs
Front Lifting
Points
Front Tie Down
Rear Tie Down /
Lifting Points
Forklift Pockets