Snorkel X Series-sn13600-15019 - Manual (Page 2)

2
Figure 1: Chassis, Left Side Figure 2: Controller
Introduction
This manual covers all models of the X-Series
Work Platforms. This manual must be stored on
the machine at all times.
Pre-Operation and Safety
Inspection
Read, understand and follow all safety rules
and operating instructions and then perform
the following steps each day before use.
1. Open modules and inspect for damage, oil
leaks or missing parts.
2. Check the level of the hydraulic oil with the
platform fully lowered. Open the Left Module
and remove the reservoir cap, oil should be
visible in the filler screen. Add ISO #46 hydrau-
lic oil if necessary.
3. Check that fluid level in the batteries is correct
(See Battery Maintenance, Page 8).
4. Verify batteries are charged.
5. Check that A.C. extension cord has been
disconnected from charger.
6. Check that all guardrails are in place, the Slide
out Deck Extension is secured with the pin and
all fasteners are properly tightened.
7. Carefully inspect the entire work platform for
damage such as cracked welds or structural
members, loose or missing parts, oil leaks,
damaged cables or hoses, loose connections
damaged or missing labels, and tire damage.
8. Move machine, if necessary, to unobstructed
area to allow for full elevation.
9. Turn Chassis and Platform Emergency Stop
Switches ON (Figure 1 & 2) by pulling the
button out.
10. Turn the Chassis Key Switch (Figure 1) to
CHASSIS.
11. Push Chassis Lift Switch (Figure 1) to UP
position and fully elevate platform.
12. Visually inspect the elevating assembly, lift
cylinder, cables and hoses for damage or erratic
operation. Check for missing or loose parts.
13. Verify that the Depression Mechanism Sup-
ports have rotated into position under each
module.
14. Partially lower the platform by pushing Chassis
Lift Switch to DOWN, and check operation of
the audible lowering alarm.
15. Open the Chassis Emergency Lowering Valve
(Figure 3) to check for proper operation by
pulling and holding the knob out. Once the
platform is fully lowered, close the valve by
releasing the knob.
16. Turn the Chassis Key Switch to DECK.
17. Close and latch the module doors.
18. Check that route is clear of persons, obstruc-
tions, holes and drop-offs, is level and capable
of supporting the wheel loads.
19. Unhook Controller from guardrail. Firmly grasp
Controller while performing the following
checks from the ground.
STAND CLEAR of the work platform while
performing the following checks.
Protect control console cable from possible
damage while performing checks.
20. Pull Emergency Stop Button out to the ON
position.
21. Position Function Switch to DRIVE. For 20W,
26, and 31 models, use both HI and LOW
drive when performing step 22.
22. Grasp the Control Lever so the Interlock Lever
is depressed (releasing the Interlock Lever
cuts power to Controller), slowly position the
Control Lever to FORWARD then REVERSE
to check for speed and directional control. The
farther you push or pull the Control Lever from
center the faster the machine will travel.
23. Push Steering Switch RIGHT then LEFT to
check for steering function.
24. Push in the Emergency Stop Switch Button.
25. Rehook Controller on side guardrail.
Interlock
Lever
Steering
Switch
Function
Switch
Emergency
Stop Switch
Control Lever
Control Fuse
Key Switch Chassis Lift
Switch
Hourmeter
(Optional)
Chassis
Emergency
Stop Switch
Pot Hole Protection
Support