Snorkel X Series-sn13600-15019 - Manual (Page 5)

5
Figure 4: Parking Brake Release (X31N Shown)
Parking Brake Release (Figure 4)
Perform the following only when the machine will not
operate under its own power and it is necessary to
move the machine or when towing the machine up a
grade or winching onto a trailer to transport.
Note: X31N models have two identical brake
adjustment nuts located on both sides of the
ladder.
The Brake Adjustment/Release Nut(s) is (are)
located at the rear of the machine to the right (and
left) of the ladder.
1. To release the brakes turn the nut(s) counterclock-
wise until the brakes disengage from the tires.
2. The machine will now roll when pushed or pulled.
3. To reset the brakes, turn the nut(s) clockwise
until the brakes have fully engaged the tires.
Test the brakes on a 23 % slope before return-
ing the machine to service.
Never operate work platform with the
Parking Brakes released. Serious injury or
damage could result.
Never tow faster than 1 ft./sec. (.3m/sec.).
After Use Each Day
1. Ensure that the platform is fully lowered.
2. Park the machine on level ground, preferably
under cover, secure against vandals, children
or unauthorized operation.
3. Turn the Key Switch to OFF and remove the
key to prevent unauthorized operation.
Parking Brake
Adjustment Nuts