beautypg.com

Maintenance, Tires, Battery charging – Snorkel AB46 Electric-sn1000+CE User Manual

Page 9: Battery maintenance, Hydraulic oil, Lubrication

background image

9

Maintenance

TIRES

Tire selection can affect the stability of the machine.

Use only tires supplied by UpRight unless approved

by the manufacturer in writing

BATTERY CHARGING

Charge batteries only in a well ventilated area.
Hazard of explosive gas mixture. Keep

sparks, flame and smoking materials away

from batteries.
Always wear safety glasses when working

with batteries.
Battery fluid is highly corrosive. Rinse away

any spilled fluid thoroughly with clean water.
Always replace batteries with UpRight

batteries or manufacturer approved replace-

ments weighing 120 lbs. each.

Charge batteries as follows:

1. Check the batteries fluid level. If the electrolyte

level is lower than

3

/

8

in. (10 mm) above the

plates, add clean, distilled water only.

2. Verify charger voltage switch is set to the correct

voltage.

3. Connect extension cord (minimum 12 gauge

(1.5 mm²) conductor and maximum 50 ft. (15 m)

in length) to charger plug located through the

opening in front of the chassis (see figure 7).

Connect extension cord to properly grounded

outlet of proper voltage and frequency.

4. The charger will turn on automatically.

5. When the batteries are fully charged, the charger

will turn off automatically .

BATTERY MAINTENANCE

Check battery fluid level daily, especially if work

platform is being used in a warm, dry climate.
If electrolyte level is lower than

3

/

8

in. (10 mm) above

plates add distilled water only. DO NOT use tap

water it will shorten battery life.
Keep terminals and top of battery clean.

HYDRAULIC OIL

1. Check oil level at sight gauge inside engine

compartment right hand side with the platform

fully lowered.

2. If necessary, fill to capacity with clean ISO 46

compatible hydraulic oil.

3. Lift flap located on top of chassis right side

(see figure 7).

4. Open filler / breather cap to add hydraulic oil.
5. Replace cap.

LUBRICATION

Refer to service manual for lubrication chart and

guidelines.

Figure 8: Batteries (Typical Both Sides)

Battery Disconnect

Figure 9: Hydraulic Oil Filler / Breather Cap and Oil

Level Sight Gauge

Hydraulic Oil Filler / Breather Cap

Oil Level Sight Gauge

Figure 7: Battery Charger

Ammeter

AC Cord