Snorkel AB46 Electric-sn1000+CE - Manual (Page 2)

2
English Language Section
NEVER operate the
machine within ten (10)
feet of power lines. THIS
MACHINE IS NOT
INSULATED.
NEVER operate the
boom or drive with
platform elevated
unless on firm level
surface.
NEVER position the
platform without first
checking for overhead
obstructions or other
hazards.
NEVER climb, stand or
sit on platform guardrails
or midrail.
Electrocution Hazard Tip Over Hazard Collision Hazard Fall Hazard
ALL occupants must wear an approved fall restraint properly attached to designated platform anchorage
point. Attach only one fall restraint to each anchorage point.
NEVER exceed maximum platform load of 500 lbs. (225 kg) and two (2) occupants.
NEVER exceed 45 lbs. (200 N) of side force per occupant.
NEVER Operate the machine when noise levels exceed 80 dB.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes,
drop-offs, bumps, curbs, or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER elevate the machine when wind speeds exceed 28 mph (12.5 m/sec.).
IN CASE OF EMERGENCY push emergency stop button to cut power to all machine functions.
ALWAYS close and secure gate after entering platform.
NEVER exit or enter platform while elevated.
NEVER use ladders, scaffolding, or other items to gain height; work only from the platform floor.
NEVER climb down elevating assembly while platform is elevated.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose
wire connections, and damaged cables or hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while boom is elevated, STOP, carefully retract boom and lower platform without
rotating. Move machine to a firm, level surface.
NEVER attach overhanging loads or use boom as a crane.
NEVER alter operating or safety systems without manufacturers written consent.
NEVER charge battery near sparks or open flame. Charging batteries emit explosive hydrogen gas.
NEVER replace any component or part with anything other than original UpRight replacement parts
without the manufacturer's written consent.
NEVER tow the machine. Transport by truck or trailer only.
AFTER USE, secure the work platform from unauthorized use by turning both keyswitches off and removing all keys.
SAFETY RULES