Synergy 8074 - Jeep JK Rear Lower Shock Mount Kit - Manual (Page 3)

9. Once the correct shock bracket position is determined, cut the bottom of the lower
control arm brackets off flush with the bottom of the shock brackets. A sawzall
works well for this. The whole bracket can be cut off with one cut.
10. Use the supplied 3/8 x 1” bolts to attach the shock bracket to the lower control
arm bracket. Use flat washers under the bolt heads and use flange nuts on the
inside of the lower control arm bracket. The lower nuts are easy to get to but the
uppers can be difficult. The easiest way is to put the flange nut in the end of a box
end wrench and slide the nut up the inside of the lower control arm bracket. Align
the nut with the hole. Use the factory anti-sway bar link bolts to attach the side of
the bracket to the anti-sway bar link tabs. Insert these bolts from the outside so
the nut is against the shock bracket.