Synergy 8057 - Jeep JK Front Bump Stop Spacer Kit - Manual (Page 2)

Figure 1-1
• Put the bump stop bolt though the bump stop and slide the bump stop into the bottom of
the coil spring.
• Install the coil spring while holding the bump stop spacer inside the coil spring.
When the spring is in place, align the bump stop spacer bolt with the hole that was
drilled.
• Install the bump stop bolt through the hole and the 3/8” serrated nut onto the bump stop
bolt. Hand tighten the nut and then use a 5/16” allen wrench through the coil spring to
tighten the bump stop bolt.
• Final torque should not exceed 45 ft-lbs.