Synergy 8034 - Jeep JK 2 Door Rear Stretch Kit - Manual (Page 2)

2) REMOVE STOCK REAR CONTROL ARM BRACKETS
a) Remove the stock upper and lower control arms.
b) Remove the fuel tank. You must remove the fuel tank to remove the
passenger rear lower control arm bracket and to access the inner wall of the
frame to install one of the nut tabs. Refer to the factory service manual for the
exact procedure.
c) Using a cut-off wheel, cut the sides of the lower control arm bracket as shown
below. Cut just below the welds on the frame. Be careful to not cut through
the frame. Cut the weld on the front of the control arm bracket on the bottom
of the frame.