Synergy 8002-PR60 - Jeep JK Chromoly Tie Rod for Dynatrac Pro Rock 60 - Manual (Page 2)

7. Install dust boot onto tie rod end and roll lower spring down to the bottom lip of the dust boot as pictured
below.
8. Tighten the castle nuts to 50 ft-lbs or more to align the cotter pin hole and install the cotter pins
9. Set the toe-in by turning the tie rod. The tie rod end has one left hand tie rod end and one right hand tie rod
end, so you can adjust on the vehicle by turning the tie rod. If you are taking it to an alignment shop the
factory specification is +.20 degrees +/-.03 degrees.
10. Tighten the jam nuts very tight. Jam nuts have tendency to come loose so man up and get it really tight!
Make sure to keep the tie rod ends in a neutral state when the wheels are straight.
11. Install the steering stabilizer bracket and steering stabilizer if equipped. Synergy 8003 clamp is compatible.
Or, if using hydro assist, install ram accordingly. Tie rod is 1-3/8” in diameter so be sure to use a clamp
designed for this size tubing when setting up hydro assist (Synergy part number – 3112).
Installation is Complete