Synergy 8002-PR60 - Jeep JK Chromoly Tie Rod for Dynatrac Pro Rock 60 - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8002-PR60 Jeep JK Dynatrac Pro Rock 60 Chromoly Tie Rod
Version 1
GENERAL NOTES:

The Synergy Manufacturing Heat treated tie rod replaces the Dynatrac Tie Rod in the same location.

Replacement tie rod ends are available from Synergy Manufacturing, part number 4131-L and 4131-R.

This part is designed to be used with the specific Dynatrac Pro-Rock 60 designed for a Jeep JK.
INSTALLATION:
1. Jack the front axle up so the tires are not touching the ground and support with jack stands.
2. Measure the toe in. Mark a vertical line near the middle of the tire tread on both tires. Measure between the
two lines with a tape measure when the mark is on the front of the tire, at the 3 or 9 o’clock position looking
from the side. Make sure the marks are at the same height so the tape measure is level. Note this
measurement then rotate the tires 180 degrees so the mark is on the back of the tire, measure and note that
distance. The difference between the two measurements is the toe-in, and should be about 1/8” positive.
Positive toe-in is when the front of the tires is closer together than the rear of the tires.
3. Remove the steering stabilizer and bracket u-bolts if equipped.
4. Remove the stock tie rod by removing the tie rod end nuts and separate the tie rod ends from the steering
knuckle using a tie rod separator tool or by striking the end of the steering arm with a large hammer.
5. Adjust the tie rod so that the ends are threaded all the way in. Be sure the Jam nuts are installed as well.
Note, one tie rod end is left hand thread (4131-L) and one is right hand thread (4131-R).
6. Install the dust boots onto the tie rod ends. Dust boots will ship with the lower spring pictured as shown
below.