Synergy 5801 - Jeep JK 2/4 Dr Front Grab Handle - Manual (Page 9)

16. Reinstall roll bar padding. Position J-hook in approximate area of attachment just forward of the roll bar
padding. Pull padding cover into position and slip handle through the opening for the soft top door surround as
pictured below.
17. Attach grab handle to J-hook with the 5/16” button head screw provided in the kit. Use a 3/16” allen
wrench and tighten to 14 ft-lbs. Tighten factory windshield bolt to 14 ft-lbs at this time as well.
18. Zip up roll bar padding and tuck into factory position for a clean finished look.
 Note, on soft top equipped vehicles, some will require the upper A-pillar trim to be
notched to clear the back of the handle. The picture below shows the removal of 1/8’’ of
material for clearance.