Synergy 5609 - Jeep YJ Baja Basket - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5609
YJ BAJA BASKET MOUNT
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The installation of this rack requires the removal of hard top or rear portion of soft
top. The top can be reinstalled after installation is complete.
• Installation of rack requires trimming of factory roll bar padding if still equipped.
• These mounts are designed to mount the rack approximately 3/4” above the tub
rails. The use of some 3/4” thick runners to span the tub will aide in the
installation process and leveling of the rack. That or the use of some 2” x 6”
pieces of wood on end atop the wheel tubs.
PARTS LIST:
1. (1) Large Baja Basket
2. (2) Left / Right Side YJ Mounting Plates
3. (2) Left / Right Tube Clamp Mounting Brackets
4. (4) 7/16-20 UNF 1” long bolts
5. (4) 7/16” Split Lock Washers
6. (4) 3/8-16 UNC ¾” long bolts
7. (4) 3/8-16 Stover Nuts
8. (8) 3/8” flat washers.
INSTALLATION:
1) Remove the factory hard top or the rear portion of the soft top to gain access to
the rear portion of the cage.
2) Remove the factory rear seat
3) Remove the rear upper seat belt turning loop.
4) Unzip the factory C-pillar roll cage padding cover and padding.
5) Unpack the YJ Baja Basket and all the included components.