Synergy 5502/4 - Jeep JK 2/4 Dr Rocker Guard Set - Manual (Page 4)

Drill Through These Holes
13. After all rocker panel holes are drilled, remove the rocker guards from the
vehicle.
14. Drill 17/32” holes through the JK rocker panels at all rocker panel hole locations.
A step drill is recommended for sheet metal drilling and it will have the 17/32”
size.
15. Next install the nutserts with the provided tool. Thread the nutsert onto the tool.
Insert the nutsert through the hole on the rocker panel. Using wrenches tighten the
tool to expand the nutsert into the rocker panel sheet metal. Repeat this step for all
twenty mounting locations.
16. Reinstall each rocker guard with the supplied hardware.
Installation is Complete