Synergy 5502/4 - Jeep JK 2/4 Dr Rocker Guard Set - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5502 / 5504 - Synergy Jeep JK Rocker Guard Set
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
Tools Required: Cut off wheel, grinder, drill and an extra pair of hands for lifting.
INSTALLATION:
1. Remove stock rocker guard assembly from vehicle.
2. Trim body mounts on frame using a grinder with a cut off wheel or tool of your
choice. The Front body mount must be cut on the rear portion as shown in
figure 1. The Rear body mount requires cutting on the front portion as shown in
figure 2. For all body mount cuts: The top of the cut should extend 3/4” below the
bolt mounting surface of the body mount.
Figure 1