Synergy 5022-02 - Jeep JK Frame Side RLCA Gusset Kit - Manual (Page 9)

IMG 8.4 - Gas tank skid section to be trimmed if gusset trimming is not desired.
9) Drain the gas from the tank if it’s not close to empty. You can do this by removing the filler hose form
the fuel tank and inserting a drain hose, it needs to be a small hose because there is a flapper valve
installed into the opening.
10) Remove the stock T-case skid plate or any aftermarket T-case skid plate
11) Loosen and remove the passenger side rear lower control arm bolt, pull the bolt out so it is flush with the
inside of the lower control arm bracket
12) It is very helpful to remove and install the tank if you remove the right rear coil spring and disconnect
the drive shaft at the pinion
WARNING: The fuel system is under constant pressure even with engine off. Before servicing fuel rail,
fuel system pressure must be released.
13) Remove fuel fill hose clamp (2) at rear of tank (3).
14) Remove fuel fill hose (1) from fuel tank.