Synergy 5000 - Jeep TJ Front Coilover Bracket Kit - Manual (Page 2)

Figure 1 Mark the stock shock mount to be cut
2. Mark the rear and the top of the stock shock mount as shown in the picture
(Figure 1).
Figure 2 - The finished cut should like this
Note: DO NOT cut the bump stop mount off unless you are upgrading to our
hydraulic bump stop kit (PPM -5002).
3. Position the new shock mount bracket. This will provide a rough guide for cutting
the inner fender. The hole only needs to be large enough to fit the shock mount. If
your inner fender has been removed, ignore this step. See Figure 3
Figure 3
4. Clean off any paint around the edge of the shock mount where you will be
welding. Clamp the shock mount in position. Bolt the over-engine cross bar to the