Lukas Concrete crushers - Manual (Page 23)

23
8. Dismantling the equipment / deactivation following
operation
8.1 Recycling unit
8.2 Hydraulic unit
Once work has been completed, the crusher arms must be closed so that there is a tip
distance of just a few mm. This relieves the hydraulic and mechanical stresses on the device.
Free the recycling unit of any stubborn dirt which may have become attached during use.
If the equipment is to be stored for a longer period of time, the exterior must be cleaned
completely and the mechanical moving parts lubricated.
Avoid storing the recycling unit in a damp environment.
Please also observe the separate operating instructions for the hoses.
NOTE:
Never store the Concrete Crusher with fully-closed blade arms! The complete
closure of the crusher arms can cause hydraulic and mechanical stress to build
up again.
8.3 Hoses
Upon completion of work, the unit must be deactivated.
First of all, decouple the pressure hose then the return hose as described in chapter
“Connecting the equipment”.
Ensure that you put the dust protection caps back on to the couplings.