Lukas SC 350 E - Manual (Page 17)

17
During cutting, the gap between the blade tips (in the transverse direction) must not be
exceeded, otherwise the blade is in danger of breaking:
ATTENTION!
Avoid cutting through the hardest parts of the vehicle body (e.g. lateral collision
protection), as this may result in damage to the cutters or to more wear and tear!
eDraulic tool max. gap on the blade tips
[mm] / [in.]
S 311 E 3 / 0.12
S 700 E 3 / 0.12
SC 250 E 3 / 0.12
SC 350 E 3 / 0.12
Higher cutting capacities can be achieved by cutting as close as possible to the blade’s pivot point.
RIGHT
WRONG
6.3 Spreading (spreader and combi tool)
Use the front area of the tips for increasing the gap only. To increase grip and to avoid having
the tips slip or break out of the part to be processed, the grip should be reapplied at an early
stage. In any case, the highest force is developed in the rear area of the plug-on tip or in the
rear spreading area of the combi blades.
WARNING / CAUTION / ATTENTION!
The light metal alloy spreader arms must not be damaged.
Spreading
Enlarging a gap
approx. 25 mm
approx. 1 in.