Apple Power Macintosh 8200 - Manual (Page 99)

Check that both chains of devices are terminated properly. For information
on setting SCSI ID numbers and terminating a SCSI chain, see Chapter 3
of this manual and the manuals that came with your SCSI equipment
m Test the disk following the instructions that come next.
How to test a hard disk
You can test an Apple SCSI hard disk with the Drive Setup program, which is
on the floppy disk labeled Disk Tools that came with your computer. If your
computer has a built-in CD-ROM drive, and you didn’t receive floppy disks,
you can find the Drive Setup program on the CD-ROM disc that contains
system software.
1 Start up your computer from the Disk Tools disk or the CD-ROM disc that contains
system software.
See “Starting Up From a CD-ROM Disc” or “Starting Up From a Floppy
Disk” in the section “Initializing a Hard Disk” earlier in this chapter.
2 Open the Drive Setup icon.
You may need to look in a folder called Utilities to find Drive Setup.
3 In the list of drives, click the disk you want to test.
99 Troubleshooting