Class1 Vernier Throttle for Cummins - Manual (Page 3)

3
DOC 101058C_c:\manuals\throttles\cummins\cumthrot.p65
Interlocks
NOTE: The interlock schemes shown in this manual are examples only and may not be suit-
able for specific applications. The throttle interface is active whenever power is applied.
Special Programming There are no special programming configurations required for the
Cummins Celect and Celect Plus engines. The control data link (J-1922) connection is typically close
to the engine ECM.
Class1 provides a variety of engine controls that are used in a broad range of
applications, therefore it is impossible for Class1 to determine the suitability of
a particular control for any specific application. The flexibility of our products
allows them to be used in a limitless number of custom applications.
Class1
can advise you of the features that are available on a given product so that
you can determine what product will meet your needs. We believe that the
Original Equipment Manufacturer’s (OEM) engineering departments should
be qualified experts in their product field and are the authorities on product
application and safety. Since our products are typically used in safety critical
applications, the OEM must undertake appropriate testing to prevent injury to
the end user.
WARNING
!
IT IS THE PURCHASER’S RESPONSIBILITY TO DETERMINE
THE SUITABILITY OF ANY PRODUCT FOR AN INTENDED
APPLICATION, AND TO INSURE THAT IT IS INSTALLED
AND GUARDED IN ACCORDANCE WITH ALL APPLICABLE
FEDERAL, STATE, LOCAL AND NFPA SAFETY AND HEALTH
REGULATIONS, CODES AND STANDARDS.