AEM 30-3352 V2 Water Methanol Nozzle and Controller Kit Multi Input Controller - Manual (Page 3)

Page 3
Introduction
Congratulations on your purchase of the AEM Water/Methanol Injection Kit. This document will
help guide you through the setup and installation process. Please take the time to review its
contents prior to installation. Pay especially close attention to any bolded text, as it indicates an
important note, or step in the process.
Before beginning installation of electronic components please disconnect the ground side of the
battery. This is for your safety.
Specifications

200 PSI injection pump

Progressive pump controller with “Boost Safe” feature

High amperage pump driver with over-current, over-voltage and under-voltage protection

Error protection output with over-current, over-voltage and over-temperature protection

Two system status LED indicators; shows pump duty cycle and system errors

Pump open and short detection and indication; works even if the pump is off

Test button that manually triggers pump

Two dial pump speed control
Hardware Kit: 35-4512HW
Quantity Description Part #
36 in 3/8" High Temp Wire Wrap 8-169
6 in Edge Protector 8-111-E
1 1/8” Tee Fitting 35-2147
10 6” Zip Tie 8-113-E
4 Bolt, Hex Head, 5/16-18 x 1.25” 1-2115
4 Bolt, Hex Head, 8-32 x 1.5” 1-2116
8 Screw, Pan Head #8 x 1.0" 1-3048
4 Screw, Pan Head #6 x 0.5" 1-3049
4 Nut, Nylock, 5/16-18 1-3055
4 Nut, Nylock, 8-32 1-2537
12 Washer, #8 x 3/4" 1-3051
4 Washer, #8 x 7/16" 1-3050
4 Washer, 5/16 1-3031-E
4 Washer, Fender, 5/16 1-3054
1 5mm Cockpit LED 35-4505
2 Butt Connector, 14-16 AWG (blue) 8-360
9 Butt Connector, 18-22 AWG (red) 8-361
4 Ring Terminal, 14-16 AWD (blue) 8-354
1 1/4" Hose Routing Strip 35-4500-20
Parts List:
Quantity Description Part #
20 ft High Pressure ¼” Nylon Hose 35-4500-20
1 200 PSI Pump With Integral Fittings
5843-2S0D-
B744AM
1 Progressive Injection Module 35-4551
1 12 ft Wiring Harness 35-3451
Injector Nozzle Kit: 35-4546
Quantity Description Part #
1 Jet, Medium (500 cc/min) 35-4514-02
1 Jet, Small (250 cc/min) 35-4514-04
1 Jet, Large (1000 cc/min) 35-4514-05
1 Nylon Washer 35-4517
1 Injector Body 35-4515-2
1 H2O Nozzle 35-4545