AEM 30-3351 V2 Water Methanol Injection Kit Multi Input Controller - Manual (Page 5)

Page 5
Installation Checklist
The following list of steps is an overview of the installation process. A complete and more
detailed list of each step including optional peripherals is defined later in this document.
□ Install Tank
o Fasten with 4 of the 8 supplied #8 sheet metal screws along with the 4 large
washers or the 5/16-18 bolts and Nylock nuts.
□ Install Pump
o Select suitable location for pump near and below the lowest fluid level of tank.
o Fasten with 4 of the #8 sheet metal screws along with the 4 small washers or the
#8-32 bolts and Nylock nuts.
o Cut supplied nylon hose with a sharp razor blade and install from tank to pump.
□ Install Controller
o Disconnect ground side of battery during electronic installation.
o
Find suitable location for controller inside driver’s compartment.
o Find l ocation in driver’s field of view and install external LED.
o Follow the wire diagram and connect wires from supplied wire harness.
o Connect the blue wire to external input signal
□ Flush Tank
o Connect the remainder of hose to pump. (DO NOT CONNECT NOZZLE)
o Fill Tank with Water (AEM recommends using Distilled Water).
o Turn on key power to power on controller.
o Use Test button on controller to flush the tank into a separate container.
o Drain tank and proceed to next step.
□ Connect Nozzle to System
o Select nozzle and connect to nylon hose.
o Fill tank with Water.
o Use Test button on controller to test complete system.
□ System Check
o While pushing the Test button ensure that no errors are reported and that the
system is producing a gradually increasing flow out of the nozzle.
o This may require pressing the Test button multiple times to purge the system.
o Drain tank and fill with desired Water/methanol mixture.
o DO NOT use a hydrocarbon fuel. Water/Methanol are the only supported fluids
□ Install Nozzle
o Find a suitable location to install nozzle. Nozzle must be mounted before the
throttle plate. Nozzle should also be mounted after the MAF sensor if present.
Nozzle must also be mounted after any intercoolers.
o Install nozzle, follow instructions for modifying intake to accept the nozzle.
o Cut and install nylon hose from pump to nozzle. Ensure that the hose is not
resting, near, or running on any moving or “hot” parts.
□ Tune Engine
o Engine tuning is usually required in order to maximize potential power gain.