AEM 30-3301 V2 Water Methanol Injection Kit HD Controller - Manual (Page 3)

Page 3
Introduction
Congratulations on your purchase of the AEM Water/Methanol Injection Kit. This document will
help guide you through the setup and installation process. Please take the time to review its
contents prior to installation. Pay especially close attention to any bolded text, as it indicates an
important note, or step in the process.
Before beginning installation of electronic components please disconnect the ground side of the
battery. This is for your safety.
Specifications

1 Gallon tank with integral level sensor for 30-3300

5 Gallon tank with integral level sensor for 30-3301

200 PSI injection pump

Progressive pump controller with “Boost Safe” feature

High amperage pump driver with over-current, over-voltage and under-voltage protection

Error protection output with over-current, over-voltage and over-temperature protection

Two system status LED indicators; shows pump duty cycle and system errors

Pump open and short detection and indication; works even if the pump is off

Test button that manually triggers pump