AEM 25-111BK High Volume Fuel Rail - Manual (Page 3)

3) Stock fuel rail and injector removal
a) Remove the bolts securing the engine cover brackets. (Figure A)
b) Disconnect the fuel inlet fitting at the fuel rail. (Figure B)
c) Disconnect the wire connectors from the fuel injectors. Remove the bolt securing the ground strap on
the fuel injector wiring harness. Remove the harness holder from the holding tabs. Remove the wiring
harness from the harness holder. (Figure C & D)
d) Remove the injector clip from the injectors. (Figure E)
e) Remove the nuts securing the fuel rail to the intake manifold. (Figure F)
f) Remove the fuel rail and injectors from the vehicle. (Figure G)
g) Inspect all seals, o-rings, and washers. If any of these components look at all worn or damaged, then
replace with genuine Honda parts.
Figure A Figure B
Bolts Fuel Inlet Fitting
Bolt
Wire Connectors
Figure C
Holding Tabs
Figure D
Figure E
Injector Clips
Figure F