AEM 23-802BK Tru-Time Adjustable Cam Gear User Manual
Page 3
Getting started
a) The procedure to change the gears is similar to the timing belt replacement procedure outlined in
the factory service manual.
i) Note: This would be an appropriate time to replace the timing belt if replacement is
due or is close to the replacement interval.
b) Obtain a suitable box or container to hold the hardware that will be removed from the engine
during this installation. This will aid in the prevention of lost nuts and bolts.
c) Disconnect the negative battery terminal before starting these procedures.
d) Raise the front of the vehicle and support on jack stands. To ensure maximum safety use jack
stands that are properly rated for the task.
e) Remove the four nuts securing the driver side wheel and tire. Remove wheel and tire and set
aside.
2) Removal of the stock cam Gear
a) Remove the spark plug wires. Remove the cap nuts and washers securing the valve cover to
the cylinder head. Remove valve cover. Remove the bolts securing the middle cover. Remove
the middle cover. Remove the rubber plug to expose the belt tensioner adjustment bolt.
B18B & H23A