Rock-Slide Engineering RAM STEP SLIDER - Manual (Page 7)

Installation Instruction RSEI 108
20. Bolt the bottom of the bracket into the step slider body with a 7/16” bolt and washer.
Tighten the bolt into the step slider, then tighten the body bolt to make the bracket tight
21. When the slider is mounted make sure that you have not twisted or manipulated the
shape of the slider with you tightening sequence. THIS WILL CAUSE THE STEP TO NOT
WORK PROPERLY.
22. Double check all bolts to verify components and hardware are installed correctly and
securely to the truck
***Please note: Expect some variance in parts that may require you to adjust the
tension of bolts to make parts fit correctly and properly. Once all parts are installed,
we suggest then fully tightening all bolts again to fit securely***
If you have any questions please contact Rock-Slide Engineering @ 435-752-4580
WIRING HARNESS INSTALL