Rock-Slide Engineering RAM STEP SLIDER - Manual (Page 4)

Installation Instruction RSEI 108
5. Hold the bracket up against the truck panel matching the body angles. Position the
bracket so that the back of the bracket is up against the panel seam. This should leave
the top of the bracket in approximately a level position when installed on the truck,
providing a level bracket for the slider to sit on
6. Bolt the bracket to the truck using the 7/16” bolts and a 7/16” washers. Bolt through
the bracket into the nutsert for each hole on the top bracket
7. Attach the top bracket to the truck
a. Hang bracket on truck and bolt through bracket into the nutserts. Leave bolts
loose until all bolts are installed. Go back and tighten bolts until the bracket is
firm against side of truck
Top bracket installed correctly