Rock-Slide Engineering RAM STEP SLIDER - Manual (Page 5)

Installation Instruction RSEI 108
8. Install the back bracket
9. Line up the bracket holes to the matching factory holes
10. Bolt the bracket to the truck using the 7/16” bolts and a 7/16” washers. Bolt through
the bracket into the nutsert for each hole on the top bracket
11. Set step slider body onto installed top bracket
12. Place step slider in place and ensure holes from top bracket and back line up with holes
on the step slider body. Brackets can be adjusted slightly by loosening bolts.
13. Make sure wires are run from the step slider body through the hole in the back bracket
14. Bolt the step slider body to the brackets
15. Insert the stainless steel allen head bolts and tighten. BE SURE TO TIGHTEN THESE
BOLTS COMPLETLEY. DO NOT OPEN THE DOOR WITH THESE PARTIALLY INSTALLED,
IT COULD DAMAGE YOUR DOOR.
a. Make sure you put included anti-seize on bolts, since it is stainless steel and
when stainless steel is bolted into steel it can be hard to remove