Rock-Slide Engineering TUNDRA SERIES – STEP SLIDER - Manual (Page 9)

Installation Instruction RSEI 131
8. Inside the truck, route the rear passenger door sensor wire along the doorframe; and
using a sticky pad, mount the sensor underneath the door latch
a. Pull the rubber door seal away from near the latch and run the sensor wires
under the seal.
b. Connect the blue/white wire to the door sensor
c. Place a small piece of electrical tape on the sensor wire to secure the wire from
the truck and protect it on the metal seam
9. While moving to the front passenger door, run the harness under the door sill. Just as
for the back door, route the front passenger door sensor wire up near the latch and
under the door seal.
a. Connect the green/grey wire to door sensor
b. Place a small piece of electrical tape on the sensor wire to secure
10. Returning to the backseat, complete the driver’s side. Run the actuator wires from the
step slider through the floor of the vehicle and plug into the wiring harness. Plug into
the red/black connector into the wiring harness.
a. Secure wires to minimize slack so they are protected. We recommend zip ties
b. *Optional: The brown/tan wire is used if LED light package is being installed
11. Route the rear driver’s side door sensor wire along the doorframe; and using a sticky
pad, mount the sensor underneath the door latch
a. Connect the orange/pink wire to the door sensor
b. Place a small piece of electrical tape on the sensor wire to secure
12. Continue to route the harness wires along the door sill and just like performed on the
passenger side route the door sensor wire up the doorframe and using another sticky
pad, mount the sensor below the door hatch.
a. Connect the orange/yellow wire to the door sensor
b. Place a small piece of electrical tape on the sensor wire to secure
13. Drill an 18 mm hole to mount the cutoff switch. We recommend using a blank switch
spot or near the emergency break release (see picture below).