Rock-Slide Engineering TUNDRA SERIES – STEP SLIDER - Manual (Page 5)

Installation Instruction RSEI 131
9. Attach the top bracket to the truck
a. Hang bracket on truck and bolt through bracket into the nutserts. Leave bolts
loose until all bolts are installed. Go back and tighten bolts until the bracket is
firm against side of truck
10. Set step slider onto installed top bracket
11. Place step slider in place and put two countersunk bolts in the matching holes to hold
the slider in place. BE SURE TO TIGHTEN THESE BOLTS. DO NOT OPEN THE DOOR
WITH THESE PARTICALLY INSTALLED IT COULD DAMAGE YOUR DOOR.
a. Make sure you put included anti-seize on bolts, since it is stainless steel and
when stainless steel is bolted into steel it can be hard to remove
11. Attach the back bracket to step slider body with two or three bolts and position it in
place as to where to secure it to the truck. Tighten the bolts to hold it in the desired location.
12. Make sure wires are run from the step slider body through the hole in the back bracket
13. Mark location of holes from back bracket into body of truck
14. Drill 5/16” holes into the pinch seam of the body
15. Remove the step slider to enable you to bolt the back bracket onto the truck
16. Bolt back bracket onto truck with provided bolts, nuts and washers. Bolt through the
bracket and pinch seam and put the nuts on the back side of the pinch seam
17. Tighten all the bolts on the back bracket