Rock-Slide Engineering TUNDRA SERIES – STEP SLIDER - Manual (Page 11)

Installation Instruction RSEI 131
20. Position the actuating magnets on the catch side of each door
a. Make sure the actuating magnets are in perfect line with the sensors
b. **DO NOT allow the magnet and sensor to come into direct contact. This
will destroy the sensor making it unusable**
c. Once that proper placement is achieved we recommend using a permanent
marker to outline the magnet on the door.
21. Re-check all wires to make sure they are completely secure and free from coming into
contact with any moving part to prevent system damage due to a cut wire
22. Reinstall all internal plastic and carpet pieces that were removed.
23. Make sure that all wires are tucked back and out of heavy traffic areas on the floor.
a. Route them toward the furthest back area underneath the rear seat
24. Close all doors
25. Insert the fuse into the holder on the POS+ side of the battery
26. Get in the vehicle. Start it and then turn the cutoff switch into the ON position. The red
Led light should come on. The system is now active. Wait for 10 seconds so the system
can check the system. Open your door and the step will actuate.
MAINTENANCE OF THE STEP SLIDER
 Please note the slider is a mechanical mechanism that requires maintenance to operate
properly. To keep the slider operating at an optimal level it needs to be maintained
with lubrication. We recommend using a Teflon based lubrication on the 7 indicated
points below to keep the slider operating smoothly. A good rule of thumb is every time
you change your engine oil. Heavy trail use will increase the frequency in lubrication.