Rock-Slide Engineering Ford Super Duty Step Slider - Manual (Page 4)

Installation Instruction RSEI 141
Make sure to get the front of the bracket positioned as described in step 3.
a. This works best with two people holding the bracket and a third person marking
the holes
b. With bracket in the correct location, mark the location of the holes with a
marker on the panel of the truck. These will be the locations for the nutserts to
be installed in the body.
5. Carefully drill a 7/32’’ pilot hole into the center of the marked points into the truck’s
rocker side
a. **It is extremely important these holes are drilled precisely to insure the
slider will fit properly once the nutserts have been installed
6. From the center of the pilot hole, step up the hole size using a ½” bit to create a finish
hole that will be used to install the nutserts
7. Install nutserts and 1/2” washer in the holes that were just drilled into the body of the
truck