Rock-Slide Engineering Ford Super Duty Step Slider - Manual (Page 3)

Installation Instruction RSEI 141
STEP SLIDER INSTALLATION
1. Remove the stock rocker panel guards or tube steps if equipped
2. The top bracket will be installed first (If the brackets are not symmetrical make sure
you install the correct bracket on the correct side)
3. The bracket start point is at the body seam near the front door. (see picture below) The
bracket has a lower piece with holes which almost touches the seam. The longer top
part will go beyond the seam.
4. Find your starting point and hold the bracket up against the truck. Hold the bracket up
against the truck panel matching the body angles. Position the bracket so that the back
edge of the bracket is up against the pinch seam. This should leave the top of the
bracket in approximately a level position when installed on the truck. Providing a level
bracket for the slider to sit on in the next step
The front of the
bracket almost
touches the
seam