Rock-Slide Engineering TAILGATE TABLE - Manual (Page 3)

Rock Slide Instruction RSEI 121
4. With the tailgate table folded open, hold it in the desired position and screw it into
the tailgate. There are six holes for mounting and 6 screws provided
5. A rubber strip is provided to hold the table together tighter and ensure it does not
rattle. The rubber strip is attached to the front lip of the bottom table surface.
Hold the tailgate table to desired spot and
mark where the plastic trim needs to be
cut. Ensure the tailgate table is high
enough to clear the cargo tray
Cut the plastic
piece to allow the
tailgate table to sit
flat on the tailgate
Mounting points