Hornady Lock-N-Load Case Feeder - Manual (Page 11)

Feed Tube End
Push Rod
Feed Tube
Select the proper Feed Tube and insert it in the top of the
Feed Tube End. If you select the Feed Tube End, you will have
to use the Plastic Feed Tube Small Bushing (66).
Refer to page 13.
(When feeding some cases, such as the 357 Mag, you may
notice that the base of the case will not fall into the hole
of the Pivot every time. The base will ride on the radius of
the pivot hole. This is correct because when the Push Rod
starts to rotate the Pivot, the case will fall into the hole.)
Feed Tube
Bushing
Small
Feed Tube
Placing the Feed Tube end on
the Assembly (con't).
17
17
ASSEMBL
Y
- 11 - ASSEMBLY: CASE FEEDER