Hornady AP with Case Feeder - Manual (Page 21)

21
See Figure 13 for more details.
Figure 15: Cam rod adjustment.
If the “Cam Wire” is too high, it will:
1. Not allow the “Shell Plate” to advance. Loosen the upper nut several turns and
pull the wire down.
2. The case will hit the “Shell Plate” before it rotates. Again, loosen the upper nut
and move the wire down, but do this in small increments, as you are close.
If the wire is to low, it will:
1. Not advance the case into the shell plate. Loosen the Lower nut and tighten the
upper one to move the cam down.
Once the timing is correct, snug both nuts to the bracket and make sure the cam is
centered in the Slide. This can be adjusted manually by rotating it around the threaded
end a small amount. Tighten the nuts to complete the timing process. This timing setting
is adequate for all cartridges, and it should not be necessary to make future changes.