Hornady AP with Case Feeder - Manual (Page 16)

16
Step 10: Feed Tube Mounting Bracket to the square tubing.
See Figure 10 for more details.
Figure 10: Feed Tube Mounting Bracket with square tubing.
• Put a ¼” Flat Washer (#48) on a ¼-20 X 1 ½” Cap Screw (#70).
• Slide the Cap Screw (#70) thru the Square Tubing and place the Feed Tube
Mounting Bracket (#16) over the Cap Screw (#70), then insert the Hex Nut (#26)
on the Cap Screw and tighten. Make sure that the top of the Feed Tube Mounting
Bracket (#16) is level. Check with a small level if you are unsure.
¼-20 x 1 ½” Cap Screw (Full Size)