CARR 210914 Rota Light Bar - Manual

Quality and Style that Endures
Follow the diagram and the written
directions carefully for a proper,
safe installation.
Should you encounter an unusual,
unforeseen problem, contact our
Technical Help Line
7:00 AM – 3:00 PM Pacific Time
(951) 719-1068
Visit our web-site at
www.CARR.com
Carr Pattern Co., Inc.
2
Rota Angle Casting
Mounting End Castings
3
Cross Bar
5/16" Bolt
1 Rota Hood Casting
5/16" Bolt
3/8" Bolt
1/4" Bolt
Split Lock Washer
Windshield
Welded Nut
Bend Rubber Gasket
Tinnerman Nuts
This is the open end of Casting (1).
Measure from this point on each
Casting (1). (See step 22 on Light
Bar Mounting Instruction)
WARNING!
THIS CARR LIGHT BAR IS DESIGNED TO HANDLE A TOTAL
WEIGHT OF FOUR (4) LBS. ANY ADDITIONAL WEIGHT
BEYOND THIS CAPACITY, MAY RESULT IN SERIOUS
DAMAGE TO YOUR VEHICLE AND/OR ANOTHER VEHICLE.
MATERIALS NEEDED: Drill motor, 5/16” drill bit, hammer, center punch, ½”
drill bit, hacksaw.
MATERIALS FURNISHED: One hardware pack, two end castings, four Rota
castings, cross bar, instruction page.
ROTA LIGHT BAR MOUNTING INSTRUCTIONS
Part No’s: 210911, 210912 & 210914
THIS LIGHT BAR FITS THE FOLLOWING VEHICLES:
JEEP
‘76 – ‘95 Jeep CJ/YJ Wrangler