CARR 124994 Super Hoop Multi-Mount Step - Manual

Super Hoop Multi-Mount Step Installation Instructions
Part No’s: 124991 / 124992 / 124994
Quality and Style that Endures
Follow the diagram and the written
directions carefully for a proper,
safe installation.
Should you encounter an unusual,
unforeseen problem, contact our
Technical Help Line
7:00 AM – 3:00 PM Pacific Time
(951) 719-1068
Visit our web-site at
www.CARR.com
M Bracket
Steel Bracket
Step Casting
5/16” x ¾” Hex Bolt
Outer Line
Outer Line
5/8”
1.
Before positioning the M
Bracket and step assembly
against the body metal as
shown in Diagram A
assemble the M Brackets
together with the steel
mounting brackets only.
NOTE: Do not attach the
step castings to the steel
brackets at this time.
2. Use the 5/16”x ¾” hex bolts and other 5/16” hardware provided
and securely bolt together the steel brackets and M Brackets.
3. Now place the step casting up into each steel bracket. Use the
¼” hardware provided and securely tighten all hardware.
See Diagram A.
4. For the proper position of the step, the front edge of the seat while
in normal driving position should be in line with the center of the
step. For personal preference or to avoid any obstruction
underneath body metal, step assembly can be moved left or right.
5. Once the desired position of the step as been found, take a pencil and mark the center of the step on the painted
body metal of your truck, on the bottom of the rocker panel.
NOTE: This operation is much easier to do while on your back. Refer to Diagram B.
6. Measure 9” from each side of the marked center line on the
same body metal surface.
7. Measure 5/8” in from the edge of the body metal, and mark
a line across the marked outside lines. Refer to Diagram B.
8. Center-punch where the lines cross, then drill them out with
5/16” drill bit.
Vehicle Application:
FORD MAZDA
‘98-‘12 Ranger 2-Door Only ’98-’09 B-Series Pick-up
MATERIAL NEEDED:
Drill motor, 5/16” drill bit, pencil, center punch, two ½” wrenches.
MATERIAL FURNISHED:
Two step castings, four zinc plated steel brackets, four M Brackets, two hardware
packs and instruction page.
WAX YOUR STEP ON A
REGULAR BASIS TO
MAINTAIN ITS LUSTER
Body Metal
Diagram A
Diagram B
Body Metal
Center Line
9”
9”
Splash Guard
Left Front
Wheel