Blaupunkt DM2000 - Manual (Page 8)

E-7
ENGLISH
FRANÇAIS
ESP
AÑOL
POR
TUGUÊS
Turn on/off message edit
You can edit the turn on/off message and store it in memory.
Following four messages (factory set) can be edit with 8 char-
acters each.
Turn-on message
• MESSAGE 1 : HELLO
• MESSAGE 2 : WELCOME
Turn-off message
• MESSAGE 3 : SEE YOU
• MESSAGE 4 : GOOD-BYE
1.
Repeatedly press the DISP to display the “ MESSAGE ”
on the display window.
2.
Rotate the dial to select the desired message you want
to edit.
MESSAGE1 ➜ MESSAGE2 ➜ MESSAGE3 ➜ MES-
SAGE4
3.
Press the MUTE / SENS , then enter the character.
A. Rotate the dial in a clockwise direction to select the
desired characters.
( A
➜ B ➜ C ➜ . . . Z ➜ < ➜ > ➜ ∗ ➜ + ➜
′
➜ - ➜ ′ ➜ /
➜ 0 ➜ 1 ➜ 2 ➜ 3...9 ➜ “ ”Space )
B. Press the TUN/ TRK to move the flashing cursor to
the next position. If you press TUN/ TRK , the flashing
cursor moves to the left.
C. Repeat steps A. and B. to complete entering the en-
tire message 8 characters max.
Tip
To erase/correct a message, press the
DISP for more than
2 seconds to clear the character and re-enter.
4. Press the MUTE / SENS to store the message.
The new message flashes.
5.
To return to the normal radio reception, Press DISP .
Note
If you make no button input or dial operation in 20 seconds,
the message edit mode will turn off automatically.
Erasing the turn on/off message
You can erase the turn on/off message if so desired.
1.
Repeatedly press the DISP to display the MESSAGE, then
rotate the dial to select the message you want to erase.
2.
Press the MUTE / SENS .
The message flashing.
3. Press the DISP for more than 2 seconds.
Repeat steps 1. and 3. if you want to erase other mes-
sage.
4. To return to the normal radio reception, Press DISP .
Demonstration mode
The unit shows a demonstration of each function.
When a demonstration is finished, it begins again after 10
seconds, and this is repeated.
1. Press the PWR to turn off the unit.
2. Press the DISP and 1 simultaneously for more than 2
seconds to activate the demonstration mode.
Press both button again for more than 2 seconds to can-
cel this mode.
Playing the CD player
Loading Discs
1.
Press the OPEN and insert the disc.
2.
Close the front panel.
Playback begins automatically.
‘‘ LOADING ’’ indicator will flash in the display window.
Note
Make sure that the front panel is closed when playback be-
gins.
Playback with the front panel open causes the
unit to turn off automatically in about 10 min-
utes.
! NEVER Insert a 3-inch CDs.
This unit is designed for playback of standard 5-inch CD’s
only. Do not attempt to use 3-inch CD singles in this unit,
either with or without an adaptor, as damage to the player
and/or disc may occur.
Tips
• When a CD is loaded, the
on the display remains lit.
• During playback of a CD, the pie-shaped signal-strength
meter spins.
CD Operations
Label side up
Key Largo (Eng) p.1-13 6/19/00, 10:02 AM 7